Question:
Can I make my own LOGO on the fire sleeve?
Answer:
Yes, we can print your LOGO on the surface of firesleeve.

Question:
What is max length of the firesleeve?
Answer:
Standard length is 20m, 25m, 30m. Max length 50/100 m for special order.

Question:
How do I ensure correct sizing of my fire sleeve?
Answer:
Sizing will depend on several factors, including the length of the line to be sleeved, number and radii of curves, surface friction of the line, and appearance required. A common ‘rule of thumb’ is to measure the outside diameter (OD) of the line, and add approx. 15% to arrive at the ideal inside diameter (ID) of the sleeve. Where the sleeve is required to pass over fittings or long lines, an additional margin should be allowed, and where appearance is critical (such as on race cars), a smaller sleeve may be acceptable. Our fire sleeve will expand to accommodate many hose fittings, however remember that tighter sleeves may take longer to fit. Some applications may have legislated size requirements.

Question:
How should I secure and finish the ends of the sleeve?
Answer:
Each end of sleeve should be finished using silicone end seal tape, which adheres only to itself and the sleeve to reduce possibility of contamination ingress. Sleeve should be fastened approx. 10mm from each end, using a stainless steel hose clamp or staniless steel cable tie. Some applications may also have legislated securing and finishing requirements.

Question:
Is all Fire Sleeve the same?
Answer:
Economic fire sleeve is standard sleeve, made by fiberglass and silicone.
Industry fire sleeve is made by heat treated fiberglass with silicone.
Aerospace grade firesleeve is made by texturized fiberglass and coated with silicone.
Knitted fire sleeve is made by knitted fiberglass and silicone.

Question:
If you are a manufacturer?
Answer:

Yes, our factory is in Anhui province, and there is 17 fire sleeve production lines, welcome to visit us or we can open face to face video to see our production lines.